Refer to the exhibit. You are the network administrator responsible
for the NProuter, the 10.1.1.1 router, and the 10.1.1.2 router. What can
you determine about the OSPF operations from the debug output? Select
the best response.
A.The NProuter has two OSPF neighbors in the “Full” adjacency state.
B.The NProuter serial0/0 interface has the OSPF dead timer set to 10 seconds.
C.The NProuter serial0/0 interface has been configured with an OSPF network type of “point- to-point”.
D.The 10.1.1.1 and 10.1.1.2 routers are not using the default OSPF dead and hello timers setting.
E.The “Mismatched” error is caused by the expiration of the OSPF timers.
Answer: B
For Best CISCO/MCITP/LINUX/EXCHANGE SERVER/PC HARDWARE AND NETWORKING Training visit www.zoomgroup.com
Join us on facebook
A.The NProuter has two OSPF neighbors in the “Full” adjacency state.
B.The NProuter serial0/0 interface has the OSPF dead timer set to 10 seconds.
C.The NProuter serial0/0 interface has been configured with an OSPF network type of “point- to-point”.
D.The 10.1.1.1 and 10.1.1.2 routers are not using the default OSPF dead and hello timers setting.
E.The “Mismatched” error is caused by the expiration of the OSPF timers.
Answer: B
For Best CISCO/MCITP/LINUX/EXCHANGE SERVER/PC HARDWARE AND NETWORKING Training visit www.zoomgroup.com
Join us on facebook
No comments:
Post a Comment